Should I just stop the pendulum until the actual time matches what the clock shows? The days will keep growing longer between March 12 and June 21, the summer solstice and the longest day of the year. Wait for the next hour count on your grandfather clock. Place a level alongside the clock cabinet from front to back and side to side, adjusting the levelers until level. Re-attach the hand to the shaft and turn the hand nut finger tight. My Grandfather Clock is a Quarter Hour Off from the chime. Unpacking You will hear a click when the minute hand reaches each quarter hour before the melody plays. Carefully remove this film before hanging the pendulum. Daylight saving time begins at 2 a.m. which is the . The movement controls the hour strike, time keeping, and chime. NEVER wind a cable drive movement without weights installed. Doing so could damage the chime mechanism. DO NOT REMOVE THE STYROFOAM BLOCKS until after your clock has been operating. https://www.theclockdepot.com/clocks-blog/grandfather-clock-does-not-chime-at-proper-time/. This happens at every hour. Comments will be approved before showing up. Make sure that the weights are hanging in the correct location Check the label on the bottom of each weight to ensure proper location. Please contact Administrator. 2. That's when local . Untie the twist-tie that is holding the cables or chains together. Once in place, your clock cabinet must be leveled, as the clock may not operate if it is not level. Step 4: Reattach the hand so it points to 1:15. Carefully remove the plastic retainer by sliding the retainer down off the chains. Not all states . Thank You, Robert.